B3-Multipath Propagation

From its-wiki.no
Jump to: navigation, search

⌘ B3-Multipath Propagation

Building .... Networks
History, Now and Future
History
Pioneers: Maxwell, Hertz,...
1G, 2G,... 5G networks
Frequencies and Standards
Future Challenges
A-Basics of Communication
Electromagnetic Signals
Radio Communication Principles
Digital communication: Signal/Noise Ratio
Signal strength and Capacity: Shannon
B-Antennas and Propagation
Free Space Propagation
Antennas, Gain, Radiation Pattern
Multipath Propagation, Reflection, Diffraction
Attenuation, Scattering
Interference and Fading (Rayleigh, Rician, …)
Mobile Communication dependencies
C-Propagation models
Environments (indoor, outdoor to indoor, vehicular)
Outdoor (Lee, Okumura, Hata, COST231 models)
Indoor (One-slope, multiwall, linear attenuation)
D-System Comparison
Proximity: RFID, NFC
Short Range: ZigBee, Bluetooth, ANT+,...
WLAN/Wifi/802.11...
Mobile: GSM, UMTS, IMT-A (WiMAX, LTE)
E-Mobility
Mobile Network mobility
IP mobility
F-Network Building
5G and Future Networks
5G Heterogeneous Networks
Basic Internet
Video Distribution Networks
Coverage simulations
Coverage simulations
Traffic simulations
Network Capacity simulations
Building .... Networks

⌘Multipath and how to use it

Multipath propagation Multipath propagation can be used through
  1. ) specific receivers (rake receivers)
  2. ) Multiple-input, multiple-output antenna systems (MIMO)

Note: The mobile phone users will typically not have a direct link between the mobile phone and the antennas of the base station in a typical environment. Such a situation, where the mobile communication has to go "around a building" or "around the corner" are called NLOS, non Line-of-Sight connection. As compared to a Line-of-Sight LOS connection the signal is typically reduced by some 20-30 dB.

⌘ Boundary conditions

  • What is happening on electrical walls, magnetic walls?
Figure: Reflection of an electromagnetic wave at the ground plane

Scattering, reflection and diffraction (explain differences) are the three major components in wave propagation. Ideal reflection environments are characterised through


⌘Comments

ReceiverCharacteristics.png

Receiver characteristics for usage of reflections in impulse response

  • sliding 16 mu s window and integration of power in this window (typical GSM)
  • Rake receiver, where each finger of the receiver points to one reflection (typical enhanced GSM, UMTS)
  • MIMO (Multiple input, multiple output) or smart antenna arrays. Here we use spatial filtering, assuming that radiation comes in from different directions (typical 802.11n, smart antennas for UMTS)


⌘ Reflection

Reflection at a perfectly plane gives a reflection coefficient r= -1. When the surface gets rougher, reflection is still in the main direction, but the reflected power is spread around the main reflection angle. Assuming that no absorption takes place, then the total reflected power is constant.

When the surface becomes extremely rough, and with roughness >> lambda, then the reflected wave will be scattered into any direction.

ReflectionScattering.png

Related physics

Free Space impedance as connection of permeability and permittivity .

. The unit of is


.

The unit of is Farad/m:

Diffraction

Diffraction is the transforming of a wave at an object, typical edge of a house ("edge diffraction") or the roof-top

Scattering

Interaction with object being about the same size as the wavelength,