Nextelco:ASA2

From its-wiki.no
Jump to: navigation, search

ASA 2

ASA 2 Connection


Initial setup

ASA 2 came with NexTelCoASA configuration. These are the steps we followed to save the configuration:

NexTelCoASA(config)#copy startup-config disk0:
Destination filename [startup-config]?NexTelCoASA_startup-config_20140522
NexTelCoASA(config)#copy running-config disk0:
Destination filename [startup-config]?NexTelCoASA_running-config_20140522
NexTelCoASA#write erase
Erase configuration in flash memory? [confirm]
NexTelCoASA#reload
Proceed with reload? [confirm]

After saving the configuration and recoverying its initial state, ASA starts with the oldest image it finds in disk0. In this case the ASA software version 7.2(3) and ASDM version 5.2(3). If there is any newer software version is convenient to change it. These are followed step.

ciscoasa(config)#boot system disk0:/asa805-k8.bin
ciscoasa(config)#asdm image disk0:/asdm-623.bin
ciscoasa#write memory
ciscoasa#reload

After this change, ASA is working with software version 8.0(5) and ASDM 6.2(3).


Specifications

This device has the following specifications:

  • Hardware
    • ASA5505
    • 256MB RAM
    • CPU Geode 500 MHz
    • Internal ATA Compact Flash 128MB
    • BIOS Flash M50FW080 @ 0xffe00000 1024KB
  • Licensed features for this platform:
    • Maximum Physical Interfaces : 8
    • VLANs : 3, DMZ Restricted
    • Inside Hosts : Unlimited
    • Failover : Disabled
    • VPN-DES : Enabled
    • VPN-3DES-AES : Enabled
    • VPN Peers : 10
    • WebVPN Peers : 2
    • Dual ISPs : Disabled
    • VLAN Trunk Ports : 0
    • AnyConnect for Mobile : Disabled
    • AnyConnect for Linksys phone : Disabled
    • Advanced Endpoint Assessment : Disabled
    • UC Proxy Sessions : 2
  • This platform has a Base license.
  • Serial Number : JMX1151Z0N8


Configuration

The official configuration guide for this software version, 8.0(5) can be found here.

Return to the Technology page.