5G Network Slicing for Free Access to Information
Wiki for ITS | ||||||
---|---|---|---|---|---|---|
|
![]() |
5G Network Slicing for Free Access to Information
by | N.n. |
---|---|
Supervisor(s) | Josef.Noll |
Due date | 2021/05/01 |
Status | Planned |
Problem description: | In Mobile Communications, 5G Research is focussing on (a) massive mobile broadband, (b) billions of sensors connected to the network, and (c) ultra-reliable and low-latency networks. A promising technology for addressing these issues is network slicing.
This thesis will look into network slicing for free access to information, and thus address the challenges of sustainable development. The free access to information (InfoInternet) is answering the needs of digital inclusion, and addresses the needs of 4 billion people currently not using the Internet. InfoInternet means free access to information for all, and addresses directly the SDG goal 9.c of the Agenda 2030. InfoInternet is further the basis ans the catalyst for SDG 3 (health), 4 (education), 5 (gender equality), 8 (decent work), 10 (reduced inequalities), 11 (sustainable cities and communities) and 17 (partnership for the goals). The envisaged Thesis will elaborate on the network slicing for InfoInternet, and evaluates the technological and societal aspects. see also: Thanh van Do, Josef Noll, Sudhir Dixit, Bruno Dzogovic, Van Thuan Do, Boning Feng, "Reducing Inequalities with 5G Internet Light Network Slice", 5G World Summit, IEEE 5G World Forum, 9-11July2018, Santa Clara, California, USA |
Methods and Tools: | The tools and methods in this thesis are based on
|
Time schedule | The envisaged time schedule (for a long thesis/60 ECTS) is:
|
Pre-Knowledge | The candidate should have a basis knowledge of networking technology and/or Internet services |
Approved | Pending by |
Keywords | Basic Internet, SDGs, Agenda 2030, InfoInternet, Network slicing, SCOTT, Digital Inclusion |
Depiction |
this page was created by Special:FormEdit/Thesis, and can be edited by Special:FormEdit/Thesis/5G Network Slicing for Free Access to Information
This page provides hints on what to include in your master thesis.
TOC
Title page, abstract, ...
- 1. Introduction, containing: short intro into the area, what is happening
- 1.1 Motivation, containing: what triggered me to write about what I'm writing about
- 1.2 Methods, containing: which methods are you using, how do you apply them
- 2. Scenario, optional chapter for explaining some use cases
- 2.1 user scenario, (bad name, needs something bedre)
- 2.2 Requirements/Technological challenges
- 3. State-of-the art/Analysis of technology, structure your content after hardware/SW (or other domains). Describe which technologies might be used to answer the challenges, and how they can answer the challenges
- 3.1 technology A
- 3.2 technology B
- 4. Implementation
- 4.1 Architecture, functionality
- 4.2
- 5. Evaluation
- 6. Conclusions
- References
Comments
Red line
Your thesis should have a "red line", which is visible throughout the whole thesis. This means you should mention in the beginning of each chapter how the chapter contributes to the "goals of the thesis".
Use of scientific methods
A thesis follows a standard method:
- describe the problem (problemstilling)
- extract the challenges. These challenges should be measurable, e.g. method is too slow to be useful to voice handover.
- Analyse technology with respect to challenges. Don't write & repeat "everything" from a certain technology, concentrate on those parts (e.g. protocols) which are of importance for your problem
References
- Wikipedia is good to use to get an overview on what is happening. But there is not scientific verification of Wikipedia, thus you should use wikipedia only in the introduction of a chapter (if you use text from wikipedia). Use scientific literature for your thesis.
- Scientific library is "at your hand", you can get there directly from UiO: [[How to get access to IEEE, Springer and other scientific literature -> Unik/UiOLibrary]]
- I suggest that references to web pages, e.g. OASIS, W3C standards, are given in a footnote. Only if you find white papers or other .pdf documents on a web page then you refer to them in the reference section.
Evaluation of own work
Perform an evaluation of your own work. Revisit the challenges and discuss in how you fulfilled them. Provide alternative solution and discuss what should be done (or what could have been done).