CITI-Sense-Mob sensor testing
From its-wiki.no
Revision as of 15:20, 5 March 2014 by Seraj.Fayyad (Talk | contribs)
| Wiki for ITS | ||||||
|---|---|---|---|---|---|---|
|
|
CITI-Sense-Mob sensor testing
| Title | CITI-Sense-Mob sensor testing |
|---|---|
| Place | UNIK |
| Date, Time | 2014/03/03, 0900-1100 |
| Contact Person | Josef Noll |
| Participants | Seraj Fayyad |
| related to Project | Citi-Sense-MOB |
| Keywords |
| this page was created by Special:FormEdit/Meeting, and can be edited by Special:FormEdit/Meeting/CITI-Sense-Mob sensor testing |
| Category:Meeting |
Status
1) earlier tests failed, no sensor signal
Potential reasons
- no power supply, - measure with multimeter
- to little power (effect) to fire up the sensor board - - don't know the power
- communication fails
On-device monitoring
- Tested the sensor with usb directly to pc and checked that there is some communication in a terminal program
- Also, open it and recheck if the sim card is correctly in the slot.
2) second test partially success, no location information, show some measured values
Potential reasons:
- static electricity
Done activities:
- Sensor discharging from static electricity
- Sensor running without SIM card then with SIM card in order
(goal): force sensor to recheck the SIM card existence
3) third test success with location identification and measurements: location identification failed potential reasons:
- some wire bad connectivity.
Done activities:
- recheck wires connectivity
- static electricity discharging.
- Partial testing for different parts of the sensor.
caution: sensor used techs for air contents measurement based on the using of ACID (chemical substance)
Needed for future testing:
- list of used commands for sensor configuration in order to simplify and accelerate testing.
- Mobile SIM card for sensors configuration.
Dunavnet 3 online data
GUI
Last measured:
Link status
- lab testing 20Dec2013, position: 59.9755117, 11.0535750 (NILU lab)
internal sensor measures: Air_Quality_bike_sensor_parameter
